Installing & Activation guide for Delphi & CDP R3.2014. Please note . if you need to activation your Delphi DS105E to R3.2014, but you did not buy ds105e vci from us, we now have Fileactivation Delphi CDP R3.2014 service, check below link. updates DELPHI DS150E software to R3.2014 version. This software version adds some new car models, such as BMW F Series. DELPHI R3.2014 software without KEYGEN, customers need to send back to us for activation, we will send the new activated to you. Installation and activation steps as below. 1. Uninstall the old version DELPHI software of your computer. Close the Internet, anti-virus software and firewalls. 2. Copy the DVD files to computer. 3. If you need to install DELPHI CAR DIAGNOSTIC SOFTWARE, click DS150E CAR 2014.R3, find Double-click to open it. As shown below: 4. Click YES, save the to your computer and then send it to us. We will activate as soon as possible and then send it back to you. After received that we send it back, click NO, then add this new file. 5. After finished, DELPHI R3.2014 is activated. Wait a few minutes, it will scan your computer and then automatically opened. Please note: if you are using R2.2014 software, your DS150E VCI need to updates before use R3.2014, method as follows. 1. Click the upper left corner of the software SETTINGS, then click HARDWARE SETUP. 2. Then you can see the following screen, click UPDATE to upgrade it! Please note, do not power off when updating DS150E VCI, also do not disconnect with computer, otherwise update will failed or damaged. Thanks for reading, we do hope this article will be helpful to you.
PREVIOUS NEXT